Informatie over | Engels woord BACKPLANE

Voorbeelden van het gebruik van BACKPLANE in een zin

• It consisted of several Eurocard PCB's with DIN 41612 connectors, and a backplane all based on a 19-inch rack configuration.
• A backplane or backplane system is a group of electrical connectors in parallel with each other, so that each pin of each connector is linked to the same relative pin of all the other connectors, forming a computer bus.
• In computing, an expansion card (also called an expansion board, adapter card, peripheral card or accessory card) is a printed circuit board that can be inserted into an electrical connector, or expansion slot (also referred to as a bus slot) on a computer's motherboard (see also backplane) to add functionality to a computer system.
• Futurebus systems were implemented with 9U×280 Eurocard mechanics using 96-pin DIN connectors, resulting in a backplane that supported both 16- and 32-bit bus widths.
• Liquid crystal on silicon (LCoS or LCOS) is a miniaturized reflective active-matrix liquid-crystal display or "microdisplay" using a liquid crystal layer on top of a silicon backplane.
• Low-profile – With the push for ever-smaller systems, a redesigned backplane that shaves inches off height requirements is a benefit to system integrators and enterprises who use rack mounts or blade servers.
• To solve this, the backplane ORs the /CFGIN and /CFGOUT signals to form the /CFGIN for the next slot (/CFGOUT is pulled low if undriven), which allows empty slots to be bypassed.
• The 1616 shared this backplane with a platform developed by Andrew Morton for Keno Computer Systems, allowing the 1616 to use expansion boards developed for the Keno Computer Systems platform (primarily the 34010 graphics coprocessor), although the form-factor was different, which left the KCS cards sticking out of the top of the 1616 case.
• VAXBI expansion cards mount into backplanes using a ZIF connector; depending on the backplane design, cards can be loaded from the top or the front side of the backplane.
• Gunning transceiver logic (GTL) is a type of logic signaling used to drive electronic backplane buses.
• NIM is still widely used for amplifiers, discriminators, nuclear pulse generators and other logic modules that do not require digital data communication but benefit from a backplane connector that is better suited for high-power use.
• Pins were snipped on the backplane, removing its status as a superminicomputer, allowing it to legally pass through the CoCom embargo.
• The Model 400 Superboard has a 48-line-wide bus at its edge, allowing it to be slotted into a backplane and take advantage of a number of expansion and peripheral boards, The Model 400 can be outfit with up to 1 kB of RAM, 512 Bytes of ROM, an ACIA chip for implementing RS-232 or 4–20 mA loop interfaces for serial communication, and a peripheral device adapter with 16 I/O lines.
• – medium (PMD): T = twisted pair, -T1 = single-pair twisted pair, S = 850 nm short wavelength (multi-mode fiber), L = 1300 nm long wavelength (mostly single-mode fiber), E or Z = 1500 nm extra long wavelength (single-mode), B = bidirectional fiber (mostly single-mode) using WDM, P = passive optical (PON), C = copper/twinax, K = backplane, 2 or 5 or 36 = coax with 185/500/3600 m reach (obsolete), F = fiber, various wavelengths, H = plastic optical fiber.
• Provide physical layer specifications (PHY) for operation over single-mode optical fiber (SMF), laser optimized multi-mode optical fiber (MMF) OM3 and OM4, copper cable assembly, and backplane.
• An extender board (or board extender, card extender, extender card) is a simple circuit board that interposes between a card cage backplane and the circuit board of interest to physically 'extend' the circuit board of interest out from the card cage allowing access to both sides of the circuit board to connect diagnostic equipment such as an oscilloscope or systems analyzer.
• The backplane designed for their Terascale switches in 2004 is the same as the Exascale systems in 2012.
• Different transmission channels such as copper cable, fiber optic cable (FOC), backplane bus or wireless systems such as WLAN can be used.
• The DEC 4000 AXP are two-way symmetric multiprocessing (SMP) capable systems that are housed in either a BA640 half-height cabinet or a BA641 19-inch rackmountable enclosure that contains two backplanes, a system backplane and a storage backplane.
• The backplane may then optionally connect to the baseboard management controller of a motherboard through an I²C or SMBus.

Paginavoorbereiding duurde: 247,34 ms.